70mm Window Sill Extension WEC 751 is suitable for most conditions requiring the weathering of External Wall Insulation Systems and Rendering. Aluminium White Coated with peel-off low tack film to protect the section during transportation and fixing on-site. Jointing pieces to suit any section can b..

70mm WEC 771 Verge OverTrim Profile is designed for use in situations where sealing the rear of the profile is possible. This profile also has an increased drip section to improve visual appearance and a large front face to help prevent the water blowing up and soaking the insulation.Manufactured in..

155mm Undersill Flashing and Window Sill Extension is suitable for most conditions requiring the weathering of External Wall Insulation Systems and Rendering. Aluminium White Coated with peel-off low tack film to protect the section during transportation and fixing on-site. Jointing pieces to suit a..

140mm Window Sill Extension WEC 751 is suitable for most conditions requiring the weathering of External Wall Insulation Systems and Rendering. Aluminium White Coated with peel-off low tack film to protect the section during transportation and fixing on-site. Jointing pieces to suit any section can ..

The WEC 781 Grind in Verge Trim Profile is designed for use in situations where there are problems sealing the rear of the profile. It is also a cost effective way to seal the system instead of increasing the roof line. This profile also has an increased drip section to improve visual appearance and..

Aluminium Bottom Section with Mesh Wing of the Render Only Compression Joint for thin coat render. Ideally suited to timber framed buildings. The aluminium base section is supplied pre-coated white, but can be powder coated to any colour if required. ..